Seven Grain Sourdough Hokkaido Milk Bread

I unfortunately am sick, but running out of bread, so I decided I needed to bake a loaf of bread that wouldn’t require excessive hands on time and allow for some inattention. This type of bread does require great gluten development since it is fully wholegrain, so I use the KA mixer to do that which takes some load off of me. I don’t need to measure pH or rise really with this since I know what the dough should look like in the pullman pan when it is done final proof. I think it turned out well considering my lack of attention to it yesterday during fermentation.



Instructions
Levain
Mix the levain ingredients in a jar or pyrex container with space for at least 300% growth.
Press down with your knuckles or silicone spatula to create a uniform surface and to push out air.
At a temperature of 76-78ºF, it typically takes up to 10-12 hours for this sweet stiff levain to be at peak. For my starter I typically see 3-3.5 times increase in size at peak. The levain will smell sweet with only a mild tang.
Tangzhong
In a sauce pan set on medium heat, stir the milk and steel cut seven grain porridge mix until blended. Then cook for several minutes until well thickened, stirring regularly with a spoon or heat-resistant spatula. Let cool in the pan or, for faster results, in a new bowl. Theoretically it should reach 65ºC (149ºF) but I don’t find I need to measure the temperature as the tangzhong gelatinizes at this temperature. You can prepare this the night before and refrigerate it, ensure that it is covered to prevent it from drying out.

If you plan on using a stand mixer to mix this dough, set up a Bain Marie and use your stand mixer’s bowl to prepare the tangzhong.

Dough
In the bowl of a stand mixer, add the milk (consider holding back 10 g of milk and adding later if this is the first time you’re making this), egg, tangzhong, salt, sugar and levain. Mix and then break up the levain into many smaller pieces. Next add the flour and vital wheat gluten. I like to use my spatula to mix until there aren’t many dry areas. Allow the flour to hydrate (fermentolyse) for 20-30 minutes. Mix on low speed and then medium speed until moderate gluten development this may take 5-10 mins. You may want to scrape the sides of the bowl during the first 5 minutes of mixing. Next add room temperature butter one pat at a time. The dough may come apart, be patient, continue to mix until it comes together before adding in more butter. Once all the butter has been added and incorporated increase the speed gradually to medium. Mix at medium speed until the gluten is well developed, approximately 10 mins. You will want to check gluten development by windowpane during this time and stop mixing when you get a good windowpane. You should be able to pull a good windowpane, not quite as good as a white flour because the bran will interrupt the windowpane somewhat.

On the counter, shape the dough into a tight ball, cover in the bowl and ferment for 2 - 3 hours at 82ºF. There should be some rise visible at this stage.

You can next place the dough into the fridge to chill the dough for about 1.5 hours, this makes rolling the dough easier to shape. Remember, if you do so the final proof will take longer. Alternatively, you can do a cold retard in the fridge overnight, however, you may find that this increases the tang in your bread.

Prepare your pans by greasing them with butter or line with parchment paper.

Lightly flour the top of the dough. Scrape the dough out onto a clean counter top and divide it into four. I like to weigh them to have equal sized lobes. Shape each tightly into a boule, allow to rest 5 mins. Using a rolling pin roll each ball out and then letterfold. Turn 90* and using a rolling pin roll each out to at least 8”. Letterfold again from the sides so you have a long narrow dough. Then using a rolling pin, roll flatter but keeping the dough relatively narrow. The reason to do this extra letterfold is that the shorter fatter rolls when placed in the pan will not touch the sides of the pan. This allows the swirled ends to rise during final proof, this is only done for appearance sake and is not necessary. Next roll each into a tight roll with some tension. Arrange the rolls of dough inside your lined pan alternating the direction of the swirls. This should allow a greater rise during proof and in the oven.

Cover and let proof for 3.5-4 hours at a warm temperature. I proof at 82°F. You will need longer than 3.5-4 hours if you chilled your dough for shaping. I proof until the top of the dough comes to within 1 cm of the top edge of the pan.

Preheat the oven to 350F and brush the dough with the egg-milk wash. Just prior to baking brush with the egg-milk wash again.

Bake the loaves for 50 minutes or until the internal temperature is at least 190ºF, rotating as needed to get even browning. Shield your loaf if it gets brown early in the baking process. After 50 mins remove the bread from the pan and bake a further 10 mins by placing the loaf directly in the oven on the rack with the oven turned down to 325ºF. You can brush the top of the loaf with butter if you wish at this point while the bread is still hot to keep the top crust soft.




That looks lovely, and you could easily have convinced me you focused on it 110%. I hope you feel better soon!

1 Like

Thank you Melissa, I always appreciate your kind words.

I just sliced some for lunch. It was nice and wheat forward yet so soft and squishy.



1 Like

Benny, you are a master at Hokkaido milk bread, especially the whole wheat version. This loaf is lovely, as usual. I’m sorry you’re feeling ill and I hope you feel better soon.
Richard

1 Like

Thank you for your kind words Richard, they are much appreciated especially when one isn’t feeling well. Despite four vaccinations for COVID-19 I got infected and progressively sicker. I finally started Paxlovid yesterday evening and finally there is a bit of improvement. I’m guessing I have one of the newer variants like Centaurian that really seem to escape the vaccine. Unfortunately most people are letting their guard down and with us heading into autumn, we need to be doing the opposite.

Stay safe everyone.
Benny

Although most of my patients have had a mild infection, recently many who have been fully vaccinated and boosted have been sicker than a dog for a week or two, and last week I saw someone who I hadn’t seen in a year, who was hospitalized for 10 days, then spent nine months doing respiratory rehab until he could return to work. My wife’s 50 year old niece felt better after a day or two on Plaxlovid, then felt crummy again for a few days before recovering. I’m of the age where I’d start Plaxlovid the second I tested positive. I was sorry to hear the president say the pandemic is over when we still need to take reasonable precautions. Take care, Benny.
Richard

1 Like

I do worry that I may rebound once the Paxlovid is completed. I’m hoping that not starting it until the 4th day gave me enough time to build some useful immunity going forward but who knows, although that wasn’t planned. I just kept expecting to improve. I think we’re going to have a much more disabled population in the future from all the long COVID that we’re seeing now that will only increase with time. Benny

Unfortunately, my daughter has struggled with long COVID for the past 2 1/2 years, since Mar 2020. She was exposed her last day of work, just when everything was shutting down, and still hasn’t been able to return. People don’t realize that even mild symptoms can lead to chronic illness.

1 Like

I’m really sorry to hear about your daughter. Yes for sure even mild COVID-19 can leave someone with long COVID-19. We really don’t want to get COVID-19 even mild cases. Two infections double your risk for coronary artery disease and three infections triples your risk. Diabetes risk also increases significantly.

@Benito Benny, This lovely loaf looks as perfect as all your other milk breads, all the more impressive for having done it when you were ill. You have this method down so well, you could probably do it in your sleep. It appears that I’m a little behind the times with this posting so I do hope you are fully recovered by now. Take care.

1 Like

Thanks so much AG. I’m not fully recovered but much improved today so that is good.
Take care as well.
Benny

1 Like